All Terrain / Offroad wheel set suitable for Mercedes-Benz V Class, Vito, Marco Polo, Horizon, Activity - Delta 4x4 Classic B 17" 235 /60/R17

The Delta 4x4 Klassik B wheel set combines 17-inch alloy wheels with all-terrain, all-season tyres for everyday driving and unpaved routes. You receive four assembled, balanced wheels, wheel bolts and tyre pressure sensors coded for the Mercedes-Benz V-Class.

All-terrain tyres with clearly defined ratings

The Loder Tire AT#1 tyres in 235/60 R17 118S are all-season tyres with M+S and snowflake markings. Speed rating S specifies a maximum of 180 km/h. Load index 118 corresponds to a load capacity of 1,320 kg per tyre. Your vehicle's approved gross weight and axle loads remain the applicable limits.

The Delta 4x4 Klassik B alloy wheels measure 17x8 inches and have an ET40 offset. Their beadlock ring carries the delta4x4 logo and is replaceable. If the ring is damaged, it can be replaced separately rather than replacing the entire wheel solely because of ring damage.

Compatible with factory suspension, subject to vehicle checks

The set is intended for the Mercedes-Benz V-Class, Vito, Marco Polo, Horizon and Activity. It can be combined with standard suspension, Mercedes-Benz Airmatic and Agility Control. Lift kits from various manufacturers and the VB Airsuspension 4C full air suspension system are also possible combinations. Suitability must be checked for your specific vehicle and suspension configuration before fitting.

When combined with VB Airsuspension 4C, an increase in the permitted gross vehicle weight to 3,500 kg may be possible, depending on the vehicle. This requires a separate assessment; fitting the wheel set alone does not increase the permitted gross weight.

Create clearance at full steering lock

The rear sections of the front plastic wheel arch liners must be modified. Without this modification, the tyres can rub against the liners at full steering lock. The plastic needs to be professionally heated and reshaped. Have a qualified workshop carry out the work and check clearance afterwards.

Plan the German individual approval with the right documents

For registration in Germany, individual approval under Section 21 of the StVZO is required. The supplied parts assessment document covers the combination with a Terranger lift kit. For vehicles with factory suspension, 1sternehotel provides reference assessment reports by email after purchase. These may support the individual assessment, but the responsible inspector decides whether the specific vehicle can be approved.

A suspension lift or additional widening is not necessarily required. The speedometer must be checked; recalibration is not specified as necessary for this wheel and tyre combination. The assessment of your individual vehicle remains decisive. Outside Germany, the relevant national registration requirements apply.

Four assembled wheels with sensors and fitting hardware

• 4 Delta 4x4 Klassik B alloy wheels, 17x8 inches, ET40.
• 4 Loder Tire AT#1 all-terrain, all-season tyres, 235/60 R17 118S, with M+S and snowflake markings.
• 20 M14x1.5x28 wheel bolts, 60° conical seat, 13.7x28 shank, 17 mm hex.
• 4 TPMS sensors coded for the Mercedes-Benz V-Class, allowing continued use of the tyre pressure display.
• Tyre fitting to all 4 wheels.
• Balancing of all 4 wheels, including balancing weights.

Check tyre pressure and route requirements before travelling

The recommended tyre pressure is 3.2 bar. Have the actual operating pressure checked for your vehicle and its load. Snow chains cannot be used with this wheel set. Take this restriction into account when planning your route.